View Single Post
  #77  
Old 09-02-2016, 05:37 PM
JAXX5's Avatar
JAXX5 JAXX5 is offline
Member
 
Join Date: Oct 2010
Location: Northeast Florida
Posts: 118
JAXX5 is on a distinguished road
More Info Please

Quote:
Originally Posted by upallnight View Post
With press in bearings, when you go to press the hub back in you need to press with a support for the inner race. By not supporting the inner race you are pushing the inner race out of the bearing.
I get this. Makes total sense to support the inner race when pressing the hub back into the bearing. However, earlier in the thread it was noted not to press on the outer edge of the bearing when installing. Did I misread that? And a 2nd question...

Since you cannot see the neck of the hub following re-install, how are you to confirm when it is fully installed... is this fully installed?
Attached Images
  
Reply With Quote

Sponsored Links