Quote:
Originally Posted by BimmerM3inGA
It looks like you're really closing in on the finish line. Can't wait to see the results of all your efforts!
It may be too early to ask, but do you have a ballpark idea of the cost to do this conversion? I did the paddle shift mod to my 4.6 a couple years ago and it's a slightly better driving experience, but isn't in the same league as three pedals and a shifter. I'm really hoping this is something that will be doable for me.
|
Good day!!
This has taken me a little while to put together... I have tried to get the exact prices I paid for this stuff, but some of it I've had for a while... Others I got for free or part of another item... The YPIY has contributed a lot to the project... Cheap parts since I am pulling them myself... So, adjust accordingly... I guess you could just pull the ballpark prices from realoem to get a better idea of actual costs involved... And you may need to add a few for welding labor if you can't do that yourself or know someone...
Clutch pedal assembly from used 540i = 25.12
Slave cylinder used = p/o clutch pedal assy
Clutch pedal = p/o clutch pedal assy
Clutch pedal switches = p/o clutch pedal assy
Trans from used 540i = 400
Flywheel from used 540i = 50
Clutch assembly from used 540i = 50
Hydraulic line new = 57.87
Grommets and other stuff =
Hydraulic hose = 2.00
Tulle = 3.49
Stopper = 0.99
Hose grommet = 6.39
Clutch pivot pin = 3.35
Pivot pin spring = 6.42
Throw out bearing new = 40.99
Pilot bearing new = 8.00
Clutch fork new = 23.42
Trans mounts new = 23.66
Cross member support bar and cross bar new =
Shifter selector rod new = 46.82
Shifter hardware new = 18.00
Shifter used = donated by my son!! THANKS BUDDY!!
E38/E39 drive shaft (front section) used = 27.88
E38/E39 guibo used = p/o drive shaft
Shifter boot new = 57.95
Shifter foam insulation new = 18.72
Shifter rubber boot = 27.31
Shifter arm support new = 51.36
Shifter arm new = 41.01
Labor
Swap pins from used 540i pedal assembly to X5 assembly.
Cut cross member and weld support bar.
Drive shaft shop = 168
Pull front drive components.
Pull automatic and associated lines.
Install transmission and associated clutch components.
Cut carpet and install hydraulic line.
Wiring
Umm...?
I add it up... Still going tho... $1159ish...
Cheers!!!