View Single Post
  #136  
Old 04-01-2019, 05:14 PM
bfeng bfeng is offline
Member
 
Join Date: Dec 2016
Location: New England
Posts: 81
bfeng is on a distinguished road
I have a couple ball holders and they all rattled a bit in the OE hitch. I wrapped the front and rear with one layer of 1” wide friction tape (a bit like racers tsps). The fit is just tight enough that I have to push and wiggle a little to get the holder into the receiver. No more rattling and creaking. The 1-layer lasts for 3-4 trips and then starts to get loose. I just perk it off and put a new piece on tape one and all’s well. Removing the bell mount takes a bit of jiggling and tugging. If the OE receiver had allowed use of one of those $15 U-bolt thingies, that would’ve been better.
Reply With Quote

Sponsored Links