Motive Products 0100 European...
https://www.amazon.com/dp/B0002KM5L0...p_mob_ap_share
You need to pressurize the reservoir with the likes of this then do the bleed procedure RR, LR, RF, LF.
When I blew my rear line (same place, manufacturing defect; the line is bent too far at the factory defeats the rust prevention), I was careful to keep enough fluid in the reservoir I never got air in the system I didn't need to bleed the front or abs block but there are two steps to bleeding the abs; the block and the precharge pump, you should be able to find in your software. Either one needs the reservoir pressurised to work properly.