View Single Post
  #1  
Old 05-28-2023, 10:51 PM
hellspcangel911 hellspcangel911 is offline
Member
 
Join Date: Jan 2014
Location: Northeast US
Posts: 50
hellspcangel911 is on a distinguished road
2011 e70 35d misfire, smooth running, inection monitoring after replacing GPs & GPR

Hi all,
You know that overwhelming feeling of disappointment when you finish the repair, start the engine and the CEL remains......hoping you guys can help me figure this out.
Car has 120k on it, it ran well but had a code for #2 glow plug and occasionally the relay. I pulled the intake, found moderate carbon build up cleaned that of, replaced all of the glow plugs, the glow plug relay, removed and plugged the swirl flaps and replaced some of the vac lines located under the intake with silicone hoses.
Cleaned everything up, new gaskets, new air filter, cleared the codes and started it up. It ran a little rough but hoped that would go away.
After a few attempts I still get rough idle at start and at temp, significant vibration/shuttering from the front right around 1800-2100 rpms and the following codes
p0270- Cylinder 4 Injector Circuit Low

4592 Smooth running Controller, Cylinder 4
4CE8 DDE MISFIRE DETECTION CYLINDER 4
459C SMOOTH RUNNING CONTROLLER CYLINDER 1
4679 FUEL INJECTION RATE MONITORING
4929 DDE INECTOR CYLINDER 4 ACTIVATION

P1729 HIGH IRREGULAR ROTATION
4F6F HIGH IRREGULAR ROTATION

So its obvious I messed something up but I'm not sure what, I was pretty meticulous when I completed this. The car is stock, I removed the swirl flaps with the intention of doing a full DEF/SCR/EGR delete in the Fall.
Before I pull the intake and check everything, any suggestions what to start with?

Thanks
__________________

2012 BMW 2012 X5 35D
2011 BMW 2011 X5 35D
2002 BMW X5 3.0l Auto (built 10/01)
2002 BMW 325i 5 spd
1989 BMW 535i 5 spd
1989 BMW 328is Auto
1987 BMW 528e Auto
1987 BMW 328iC 5 spd
Reply With Quote

Sponsored Links