I am just trying to seperate the ball joint side from the steering knuckle of the (front) rear lower control arm. I cannot tell if the pic is of the control arm or the tension strut, but the one I am referring to is the connection furthest back on the steering knuckle. first is tie rod, second is tension strut, third is control arm.

the nut that hold the ball joint in place is on the topside (as opposed to the tension strust where the nut is on the bottomside). thus I cannot fit a pitman puller tool above the joint to push it out because the axle is in the way.

I need a clamp style tool to seperate this that opens to at least 65mm.