Help! No crank no start! Repaired floor (welding)

[Hamfist]

Hey all. I finally got around to getting the holes in my drivers floor repaired.

1:disconnected negative terminal
2: removed drivers seat, 2 nuts, 2 bolts, one harness under the front.
3: lifted carpet, unhooked gas pedal, unhooked ground on the outer frame rail. Took out subwoofer in floor and moved harness out of the way
4: welded holes, sealed floor.
5: cleaned stud for ground, and copper plate on ground group. Installed and tightened nut.
6 installed speaker, carpets, seat, pedal amd all trim.
7: hooked up negative
8: all dash lights come on, depressed clutch and brake, turned key, nothing, not even a starter click.

Unhooked battery again, tried again, nothing.

Checked ground on frame rail, still tight... Wiggled it...

Battery is 2 months old, has over 12vdc.

Heeelllpppppp!

[getty150]

Charge that battery up, the make sure all connections are tight...as a bonus...change out the ground straps under the car

Sent from my SM-J727T using Tapatalk

[Hamfist]

Turns out the clutch switch is just a field effect sensor that clips on to the piston. When i put the carpet back, it got pulled off the clutch pedal.

Clipped it back on, starts perfectly.

Ugh.