|
||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
#82
|
||||
|
||||
|
You can use a hack saw to make the groove deeper. I'm concerned there is something else at play like the lever arm gear is off by one tooth but it should be a permanent fix if that's why the cable was too short.
__________________
2011 E70 • N55 (me) 2012 E70 • N63 (wife) |
|
#83
|
||||
|
||||
![]() This is the gear alignment in describing but it won't be misaligned from the factory only if you rebuilt it.
__________________
2011 E70 • N55 (me) 2012 E70 • N63 (wife) |
|
#84
|
|||
|
|||
|
Yes I just used cutters to deepen the groove somewhat.
Thank you for that picture. The reason I don't think it's the gear alignment is that I have tried 3 different carriers and I never rebuilt any of them. It seems very solid now |
|
#85
|
||||
|
||||
|
The gear alignment issue would only apply if rebuilt it can't jump a tooth unless the hinge is separated.
Makes me wonder what is the root cause of the issue since the cables should all be the same length but it's good you figured out a workaround.
__________________
2011 E70 • N55 (me) 2012 E70 • N63 (wife) |
|
#86
|
|||
|
|||
|
I replaced a broken DHC about a year ago and it's already failing. Have to pull real hard to get it to open. Is this the fix needed?
|
|
#87
|
||||
|
||||
|
AWR-Fix: Door Handle Carrier Permanent Fix*
yup. Usually can just wire back together as shown in this how-to.
I've had one case where it was broken too badly. I usually recommend getting a replacement part from a no questions asked return policy source just in case so you don't have to go with a non functioning door while waiting for a part. I usually check xo every couple hours so if you get stuck send photos I can update the help thread
__________________
2011 E70 • N55 (me) 2012 E70 • N63 (wife) |
|
#88
|
|||
|
|||
|
I think I'm going to buy a new handle and do the fix before I install it. This way I can take my time and do it on my workbench without any sort of time constraint.
|
|
#89
|
|||
|
|||
|
Okay, got my new carrier. Read over all 9 pages and the icloud photos. Because this is a brand new carrier with nothing broken, the only things I should have to do is cut off that tab and add a metal zip tie as a preemptive strike?
I replaced the carrier about a year ago and don't ever what to have to do it again. Lets say 0% is closed, 100% is all the way up. These doors typically open around the 20% mark. I currently have to yank on the handle and it will open around the 98% mark. |
|
#90
|
||||
|
||||
|
That is the exact symptom of the Hinge breaking around the axle as described in this fix.
I always put the metal zip tie around on a new one to keep it together if it breaks.
__________________
2011 E70 • N55 (me) 2012 E70 • N63 (wife) |
![]() |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
|
|