Quote:
|
Quote:
|
Yeah, I pre-baked the parts at 500F, a temperature that is a bit higher than the cure temperature for about 15 min after sandblasting. This drove the bulk of the entrapped gas out, which is more than enough in my case.
|
Quote:
Your finish should last then. |
All times are GMT -4. The time now is 10:30 AM. |
vBulletin, Copyright 2024, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0
© 2017 Xoutpost.com. All rights reserved.