Quote:
Originally Posted by bugbyte
Hey Doru,
What kind of rear backup camera are you using? Does it perfectly fit or do you have to mod it to fit and where is the location you installed it. Also if you can post the directions that you routed your cables from back to the front.
|
I think it will fit like the OE lic plate light. I haven't installed it yet - it is on Jeff's Dynavin page, haven't had time to install it yet and in my hands it looks like the OE dimensions.
Concerning the wires, they are pulled to the trunk.
In my case, they go from the dash inside the middle console (remove the carpet paneling from the gas pedal to the middle of the console and fish it.
Remove the driver seat. remove the door sills driver side front & rear. Remove the "B" pillar cover. Fish the wire where the carpet splits under the driver seat. Fish the cable under both door sills. replace the sills pillar cover and seat. Remove the rear seat. Remove the 2 plastic tool panels in the rear hatch. Fish the wire under the rear seat and in the rear hatch under the driver side carpeted panel. This is where I stopped. The wires are resting where the amp is.
here I need to make a connection around the battery where the rear signal is, and a connection to the ground for the rear camera wire.
Then it will go in the "D" pillar up through the wire loom snorkel and into the rear hatch door to the camera & lic plate light.
This is the camera, copied form Jandtdistributors (Jeff's Dyanvin page, hope he doesn't mind)
