The resistance of the four black-cap EDS solenoids should measure between 5.9 and 6.9 ohms at 20°C and their respective pins at the 16-pin connector are :

EDS 2 = pins 3 & 12
EDS 3 = pins 7 & 12
EDS 4 = pins 11 & 16 (torque converter)
EDS 5 = pins 15 & 12


Vehicle connector


Transmission connector


The green-cap main pressure solenoid (EDS 1) should measure between 5.4 & 6.4 ohms at 20°C between pins 2 & 16.

The three on-off solenoids should measure between 26 & 30 ohms resistance at 20°C :

MV1 = pins 8 & 16
MV2 = pins 9 & 16
MV3 = pins 4 & 16

Obviously these measurements only check the internal wiring and the solenoid winding integrity and not the performance of the solenoids.

Four of the remaining six pins are for the two speed sensors :

Turbine speed sensor = pins 5 & 6
Output speed sensor = pins 1 & 10

and their resistances should both measure between 285 & 365 ohms at 20°C

The remaining two pins (13 & 14) are for the fluid temperature sensor which should have the resistance characteristic shown below :



Phil