View Single Post
  #102  
Old 05-28-2016, 05:28 PM
williamx5 williamx5 is offline
Member
 
Join Date: Jun 2012
Location: South Carolina
Posts: 568
williamx5 is on a distinguished road
Good day all!

It has been some time again. I have not gotten a lot done due to parts and my new job. Four days a week at work has turned into six days a week. I'm still trying to figure that one out...

So, I have all the piston and rods in. I finished the heads and even put the VANOS on the cams noting the Pass head has the vacuum slot...







I also put the timing chains on so that I could hook up the oil pump and put the oil pans on. I took out the wheel stud in the bottom of the oil filter cap and put in the new plug I got... Mental note: if the new one gets buggered up, leave it alone!! It doesn't HAVE to come out to change the filter...







Flywheel, real main seal, and all bolts torqued... Flywheel bolts got locktite...



Okay, now the fun stuff! I got the new guide rails for the timing chains... It escaped me to get the bits that go with the new rails... Pay attention to the stuff under the new items, especially if the original old part is "ENDED"!! So, I didn't get the new bolts for the rails... Here is the difference and the reason for the new bolt...



New bolt is larger and longer... I don't have the new bolt yet... I'll explain why a little later...









And the biggest improvement noticed with these... This is incredible!!



And the last one!!



This is the issue!! I can't get more done until I get the new bolts!! I would put the cylinder heads on, but this motor needs the lower chain cover on first...



Well, I wouldn't say "NEEDS" the lower chain cover on, but things are much easier if it is...

Okay, here is the issue with the bolts...

I looked up the part number on realoem... Just like I always do... Find the correct diagram... Find the part needed... Look at the number next to that part... Scroll down until you hit that number and go across the line for the desired part number... Ahem.............. That didn't work out well this time!! It appears that not all options are designated with that number you scroll down to... Numbers 8 and 11 in my case... 8 and 11 are for the ORIGINAL bolts to be used with the "ENDED" guide rails... The new bolts that should have the 8 and 11 are listed under the new rails, but have dashes... So, I ordered two of what I already have!!!!

This is the WRONG part number for the new rails!!!



Once I get all this done, I will be making a complete and triple verified list of parts for this...

So, until I get the two bolts, I'm stuck here...

Cheers for now!!!
Reply With Quote

Sponsored Links