Hi Blue,
I used the Expert Profile to Write_FA for the CAS module, then did the same for the FRM module.
No problems!
The values I had coded in each module didn't get reset in either of them, as all of the coding that I have done previously still works.
It seemed odd since I read that the modules are supposed to get reset to factory coding...
I wasn't coding the modules with the new code for the added item to the FA.
I read another post somewhere where you stated:
Write_FA ($xxx) to the CAS then code it back to the defaults (SG_CODIEREN) with the new FA...
That all went smoothly with no issues.
Assume this is now rest back to factory defaults.
Write_FA ($xxx) to the FRM then code it back to the defaults (SG_CODIEREN) with the new FA...
Now I keep getting this error when I try to code (SG_CODIEREN) the FRM module:
COAPI-1043: error during processing CBD-file
FRM2_E70.C09
I'm pretty sure that I have the latest Daten:
Version 60.1
Downloaded from here:
https://mega.nz/#F!4pQjXRYb!YmZcD6u1taTxzmiCbn5TDA
Also I'm pretty sure that I have the latest version for NCS (3.1) and it's a fresh install that has been working fine until this activity.
Thought for sure I was about done with this, and now this Error...
This is driving me crazy!!
Thanks again you are always very helpful!
John