Quote:
Originally Posted by Gogubjp
So this is my problem ? That piston ring ?
1. If i order it, is hard to change it ?
2. If i disconnect the compresor to change the ring, the car will be low ?
3. After i change the ring, just plug back the compresor, delete the error with Inpa, and the leverl button will work to rise and low the car ?
Sorry for all my questions, but i'm a bit affrair, not to do something wrong and can't use the car anymore.
|
It COULD be your system's issue
Here is the bagpipinandy website with all the info
http://www.bagpipingandy.com
He is on your side of the pond too
Personally I used a lower cost kit off eBay that was about $13
https://www.ebay.com/itm/182674841312
Watch the videos and see how the replacement is done. Rather simple if you go slowly and meticulously.
https://youtu.be/LKqiwaxrWAk
I did not lose any air in my system when I disconnected the lines. There are probably check valves in the system to prevent loss of air.
I used Creator310 code reader to reset my errors and after changing the piston ring my system functions as designed raising and lower with switch commands.
Good Luck.
Mike