Thanks everyone for your help.

I finally got this off. The 5 lb hammer would not even budge that sucker. I could not find a 10 lb slide hammer anywhere locally. Just 5 lb'ers. I finally got bearing separator and was able to slowly work the hub from the bearing by running bolts through the hub to the separator. To do that, I had to take the brake apart. Not a big deal, just not a step that I planned on.

So there is a lot more MacGyver involved with this than expected. I was following this: https://www.youtube.com/watch?v=kyHghlHcpA0 but it wasn't quite that easy.

Pretty good but it must be a little easier with the air suspension versus the coil spring. Had to get in to some creative jacking to get the coil sprin compressed while leaving enough working room to get the bearing bolts out and back in and taking the pressure off of the shaft to allow it to move around. None of my spring compressors could even fit. I am sure there is a compressor out there that would work. But none of the three styles that I have would get it done.

I spent about 8 hours on this today. Mostly figuring stuff out. A couple of runs to the parts store for rental stuff (slide and separator). A run to the hardware store for bolts for the bearing separator.

Got the new hub / bearing installed but will have to button the rest up tomorrow.

Knowing what I know now, I bet I could do the other side in about 3 - 5 hours.