Replaced the breather tube that runs from a separator...? to the front/top/left side of the valve cover.


I broke the previous tube (very brittle) when I replaced the Intake Cam Position Sensor.


Destroying the bottom end was the only way I could remove the previous tube; terrible angle, view, and room....I said a bad word or two...lol


Seen a hard plastic 1/4" dia tube; bent at 90 degrees, in that area under the intake; I cannot see where it is supposed to terminate, but the car runs OK, no codes.


Fun


Edit: also replaced the oil filler cap, snorkle rivets, and a bolt cover on top of the valve cover....

__________________
2018 F250 STX

2002 BMWX5; 3.0i
2016 Nissan Altima (OR), 2008 Ford Escape (OR), 1998 K1500 (GA), 1990 BMW 325i (GA, KY, & OR), 1992? Ford Explorer (TX-GA) , 1987 Ford Ranger (GA), 1982 Ford Courier (TX), 1986 Mercedes 260 (Germany), 1988 Izuzu Trooper II (NC), two 1970 Jeepster Commandos (NC), 1979 Monte Carlo (NC)
1968 Ford 3/4T truck (CA), 1972 Ford Courier (CA), 1972 Ford Maverick (CA), 197? Yamaha 125 (CA), 196? Honda Trail 90 (CA)