11-05-2019, 07:47 PM
|
|
Member
|
|
Join Date: May 2019
Location: Orion Arm
Posts: 123
|
|
Quote:
Then I was getting ready to do the digital speedo in KMB, so I was reading the instructions for that in the ReadMe file that came with the software from the Romanian guy. He has the added step below of selecting 'coapiReadSgGetFswPsw', which I had also seen something about on some of the videos. I didn't do this with the first two modules I coded and it seemed to work fine - is this necessary with some modules but not others?
From the ReadMe file:
13. Search for the option “BC_DIGITAL_V” and change the value from “nicht_aktiv” to “aktiv”
14. File >save
15. Back to NCS now hit F5 for basic functions
16. Select “coapiReadSgGetFswPsw” and ok.. you are basically telling NCS to read all the values
from your FSW_PSW.MAN file. You will see a screen similar to this just press ok.
[IMG]file:///C:/Users/Tim/Documents/BMW%20Software/Diagnostic_cable/ReadMe/untitled12.jpg[/IMG]
17. Then you should get this.
[IMG]file:///C:/Users/Tim/Documents/BMW%20Software/Diagnostic_cable/ReadMe/untitled13.jpg[/IMG]
18. Press ok.
19. Ok now take a look where it says “JOBNAME = CODIERDATEN_LESEN”
20. We need to change that to a coding function because we want to write the changes to the module.
21. Select F2 “job” select SG_CODIEREN and press ok
22. Then press F3 to execute the job. Will gray out for some time.. now you will see this . notice the “coding ended’ message
|
Where is step 12?
__________________
2006 E53 4.8is - Imola Red 2, Cream Beige all day er’ day
|