Quote:
Originally Posted by Fifty150hs
You are correct, the bore as shipped is too small. I reamed mine out so the X5 splines would fit. Worked fine after doing that and grinding the top of the ring so it was perpendicular to the arms/shaft. Mine was poorly constructed, but so cheap I didn't mind spending some time modifying it if it worked. It worked well once modified.
|
Hi Fifty150hs,
Couple questions for you.
1. The round hole (factory is 30 mm), did you ream it to 32 or 33 mm?
2. The wide part (the part that says 100 mm across), is it wide enough to accommodate the wide part of the CV Joint?
I may take my tool to a local machine shop to bore the round hole bigger for me...