Bleeding Front Or Rear-Axle Brake Circuit

1. Connect bleeder hose with container to bleed valve on right brake caliper.
   
   
2. Open bleed valve.
   
   
3. Run bleeding routine with BMW Diagnosis and Information System (DIS) with bleeder valve open.
   
   
4. After running routine, press brake pedal 5 times to stop. Clear, bubble-free brake fluid must flow out.
   
   
5. Close bleeder valve.
   
   
6. Repeat procedure at left caliper.
   

CAUTION: Use only clean brake fluid. Ensure no dirt or other foreign matter contaminates brake fluid. DO NOT mix different brands of brake fluid, as they may not be compatible. DO NOT spill brake fluid on car, as it will damage paint. If brake fluid contacts paint, immediately flush with water.

CAUTION: The 4.6is with M62S engine requires brake fluid DOT4 (low viscosity). All other models can be filled with the same brake fluid.

NOTE: Check relevant operating instructions for each device. Charging pressure

should not exceed 29 PSI (2 bar).

NOTE: Take care of rubber gasket in lid

__________________
2011 E70 • N55 (me)
2012 E70 • N63 (wife)