|
Did the Foxwell show a anti tampering error in the EWS? You might go have another look and see if you have this error. If you need to resync the EWS follow these steps: Don't forget to turn off car and remove key for 10 seconds on step 6.
STEP ONE
Ensure the cars battery is fully charge or even better on a charger
STEP TWO
Plug in Foxwell and select BMW mode and then find your VIN or manually input your car. Allow the unit to run until you are at the Diagnostic/Service screen
Select “Service”
STEP THREE
Navigate and select “Drive” option
STEP FOUR
Navigate to “Electronic Car Immobilisation System” and select
STEP FIVE
Select “DME (DDE) - EWS-II Adjustment”
STEP FIVE
On the next screen select “option 2” which is starting value adjustment.
STEP SIX
Follow the on screen instructions..... but when it says start engine it doesn’t tell you you need to remove the key completely and wait 10 seconds. Then the car should start.
STEP SEVEN
Clean up Codes, go into the DDE/DDM module read the codes 4A63 code will still be there, so clear the code and then rescan you ensure it’s gone.
|