I have to say, on the air box, if you can’t find an inexpensive replacement, that may be “fixable”. I think I might be inclined to measure the gap between those ribs, since it primarily runs down one section, setup a little clamping jig and two part epoxy a “splint” to the outside of the box. Before I clamped it in the jig I’d use the epoxy to set the crack and then fill in any gaps with a 1 minute hardening adhesive like the instant grab products that come in a caulk tub. Light sand and a quick coat of black paint and I think that box may be back in service - obviously with a deep clean and degrease first [emoji16]. If you were concerned about integrity, you could heat abs plastic, mold it to the inside, down the side and along the bottom, and epoxy a “splint” inside too.

Just a thought if you don’t find one quick.


Sent from my iPhone using Xoutpost.com