Quote:
Originally Posted by Attacking Mid
Mine never had a "clean" signal from any wire in the LCM. There are two wires in the LCM that give a brake signal, but one also pulses with the turn signal, and the other seems to be slightly under-voltage, which results in my Prodigy2 controller display spazzing out. Despite the display issues, the controller DOES work, so I put up with it for a couple years. Supposedly, you can find a clean source at the high-mounted brake light on the rear hatch. I never bothered, so I can't verify.
AM.
|
I will see if I can find what wire I have, I have no problems with mine after install. Keep in mind that you need to use a PWM trailer light module as well, are you doing this or did you tap directly into the tail lights for the right/left/tail signals?
edit; 15 pin black connector on LCM Pin 10 "high mounted center stop light"
blue with yellow trace.
This is what it is for my 03 4.4, I would assume the other model years are the same but I dont know