Minor update. Raining here so not much I can really do.

My dISA has failed. The flap doesn’t budge with key in pos 2. Getting 12v at the connector but no movement. Looking for a replacement. Wondering if that along could cause electrical glitch? Still getting intermittent all four o2 failure, blessing the DISA is on the same circuit as the MAF.

Idle is fine, drives ok- just around the block.

Dashboard showing PRND but shift position not registering when switching. It used to. Seems to point to a failed position switch?

My scanner locks up when reading anything frommABS or DSC sections. Communication failure.

Was going to check the trans fluid level but my old Sears Jack failed when I got it 1/2 way raised. Scared the crap out of me even though I wasn’t underneath.

Sheesh.


Sent from my iPad using Tapatalk