View Single Post
  #1  
Old 10-18-2021, 05:43 PM
Henn28's Avatar
Henn28 Henn28 is offline
Member
 
Join Date: May 2021
Location: Louisiana
Posts: 1,093
Henn28 is on a distinguished road
Secondary Air Pump Delete

I know this topic has been hashed out many times on many forums, but I've got a quick question regarding the vacuum tube running tot he top of the check valve, from the vacuum control valve. I plan to delete the system in my swap and just want to make sure I understand it correctly.

Since I'm starting with a clean sheet basically I've got the luxury of deleting this system and saving myself the future headaches that will certainly be forthcoming with a 20 year old pump, lines, valves, etc. I need an DME tune anyway for my 4.4 DME to fully dance with the 4.6 motor I'm installing, and based on my conversations with a couple of the most recommended tuners, the EC pump is an easy delete for them to completely wipe from the DME...no codes or SES lights. Coupled with the fact that Louisiana doesn't emissions test the above makes for an easy sell to simplify the motor and preclude, in some small way, future problems.

I think the small tube simply pulls the vacuum needed to operate the valve and allow the pump to push air into the tube running into each head, and stop any backpressure from getting into the pump. A simple cap at the vacuum control valve port where this vacuum line attaches should be the answer...thoughts?

Alternatively, the "air pump vacuum control" system seems like it has two purposes only: 1) operate the above valve and 2) pull a vacuum at the air intake box...for what purposes I have no idea. Can I delete it all?

My cunning plan for capping the head ports is to chop the secondary air line ends just past the bolt flanges where they bolt onto to the heads and get an expert to weld caps on the ends. Grind the caps down flush, clean them up and then I'll install them with new O-rings and be done with it. They will stick out an inch or so, but the only blank-off plates I've found are not specifically for the M62TU motor and take two bolts, rather than one, as is the profile of the M62TU flanges in the heads that accept the secondary air line.
__________________
Current
Original owner 2002 E53 X5 4.4i to 4.6i swap
2026 G80 M3 6 spd
2025 G06 X5 50e
Former
1972 Audi Fox
1986 Saab 900S
1996 BMW Z3
1998 BMW E36 M3 Sedan
2004 BMW E46 M3
2006 Audi A3 Quatro
1993 Mopar 318 Jeep Grand Cherokee
2015 V6 Jeep Grand Cherokee
Reply With Quote

Sponsored Links