Quote:
Originally Posted by BigBody
Wayne, as strange as it sounds, I really hope I destroyed the sensor! Did not notice it at all to be honest. Looks like it definitely protrudes quite a bit. Will pull it out and inspect, many thanks again!
I ran INPA while monitoring wheel speeds. The wheel I worked on showed zero wheel speed. I dont believe it could possibly be the ABS module. It has been absolutely fine before the wheel bearing change. I will switch around the sensors if I dont see anything obvious, thanks for the tip!
|
That's good you used INPA. But just to be clear, you were spinning the wheel while looking at those signals, right? When I had mine connected up, I had to REALLY spin the wheel fast enough for the signal to register, and because of how the front diff was on my vehicle, I would get the corresponding opposite wheel to spin in the other direction and the ABS register that speed as well.
Let us know what you find out!