Originally Posted by nextelbuddy

I'm using your DIY right now to do my facelift headlights. I'm down to the part where you mention routing your Halo wiring through the original access panel for the OE Halo bulb


Curious, why did you run the wires outside of the housing instead of just tapping into the existing Halo wiring that's in the wire harness inside the headlight housing?

Since you ran your wires outside the back of the axis panel, does that mean you also ran the included wiring, harness and relay that came with your halos and wired it to an ignition two source?

I would much prefer to use the 12 volt Halo wire that's inside the housing if possible unless it's not 12 volt and actually something less.