Quote:
Originally Posted by Bmwe5320023.0
I managed to install and run DIS.
However it seems there's some connection problem.
The reason I need it, is because I want to code IHKA module. That's for my E39 1998. I sourced 2 panels from 2000 and 2001 and neither of them work. I was told that coding with DIS specifically will make them work.
I tried coding with NCS Expeert without success.
Maybe my DIS version is too new, V57? I'll try to find V44
|
Do a search on DIS connection problems at https://www.bimmerfest.com/forums/bm...ogramming.175/. If INPA is working fine, then your issue is DIS config settings and you're good to go. Take time to search. By the way, have you tried coding using NCE-Expert Dummy? It masks the complexity of NCSExpert and makes coding easy. If you can't code with NCSExpert, then I don't think any other software will as it's the most down-level and you can brick modules easily.
NCS Dummy makes working with NCS Expert a lot easier:
https://www.bimmerforums.com/forum/s...-of-NCS-Expert
__________________
'05 E53 X5 4.4i, '97 E39 528, '07 E92 335i, '16 F86 X6M.
Last edited by X5only; 11-27-2022 at 03:25 PM.
|