Quote:
Originally Posted by wpoll
Sounds like your battery voltage was getting low... a low battery voltage drives these cars crazy and you'll see all manner of codes, errors and gremlins. They all usually go away once the battery voltage recovers (is charged, replaced etc.)....
|
Perhaps you're right; the X5 had no trouble starting this morning, after charging at 1.25 amps on the Battery Tender all night (I leave all my vehicles on battery maintainers, except for the HHR Panel, which the wife uses, because she never disconnects it).
But, I disconnected the maintainer prior to my prolonged diagnostic/experimentation session yesterday, because I once had a maintainer fail after leaving it hooked-up while doing the same sort of procedures.
I have a voltage-reporting plug in the console cigar lighter receptacle, and it's always on whenever I'm in the truck. It shows the voltage usually at 12.4-12.6v before starting, and rises to 13.8-14.1v at idle (750+/- rpms). While using the Foxwell, when the engine was off, the voltage would slowly drain away to 11.8v, whereupon I would restart the engine. So, maybe you're correct that the gremlins were a result of dropping voltage levels, and extra electrical loads caused by using the Foxwell? Seems reasonable to me.
Quote:
|
Originally Posted by getty150
Low battery is a good assessment. With all that plugging, unplugging and switching you've done, the computer is confused !
But seriously, I have the Foxwell...when finished scanning...I back out of the screens all the way back to the home screen...do you?
If not , I offer this could be your problem.
|
Yeah, I got confused too, about which light would come on or go off when using the Foxwell, or if it would work at all. So, I pulled out all the OBD extension cables I was trying, and gave up on the Foxwell, and reverted to "old faithful", the bluetooth dongle+Torque Pro on my tablet. I guess that combo is OK with variable voltage.
Yes, I normally do back out, all the way to home screen, when switching test modes on the Foxwell; but, yesterday, it would hang-up in various sections for extended amounts of time, so I'd end up unplugging it entirely, and starting over. Each time, I worried that something would go awry, so when the X5 wouldn't start, I assumed that the Foxwell was partially at fault. On my other scan tool (non-bidirectional Innova 3100i), I never had this hang-up mid-test problem, that the Foxwell has. Does anyone have a Foxwell NT-510 Elite that does this?
After this testing fiasco, I'll use my Schmacher XCS15 charger/maintainer during extended sessions with the Foxwell (and with my INPA/Windows 11 laptop), to keep battery levels steady. I can choose from 2/10/15 amps to keep the battery up, when the engine's not running. I keep this charger/maintainer (+desulfator) with my tools in the trunk, so it's ready at hand. I can either feed voltage thru the plugs back there, or probably better, thru the underhood jump/charging posts. The Battery Tender, at 1.25 amps, is probably better left for long-term use.
Thank you both, this info sets my mind (partially) at ease. I might just test the battery (under 5 years old at most), while I'm testing next round.
But, ever since I started maintaining my batteries, full-time, all my batteries have lasted from 8-13 years.