Quote:
Originally Posted by Bmwe5320023.0
Thanks for the offer!
I think factory max is around 18 inHg
I'm thinking of using this gauge to measure
MEASUREMAN 2-1/2" dial, 1/4"NPT Lower, Glycerin Filled, Stainless Steel case, Brass Inside, 30inHg/-100kpa-0-30psi/200kpa https://a.co/d/aBk7onu
What's would be the easiest way to do it?
I'm thinking of just drilling a hole in the oil cap and then screwing that vacuum gauge unto it! |
I have a cap that I drilled a hole in to previously test. That is what I will use. The vacuum was really low, so low it barely moved the needle reading psi. I think I remember reading somewhere that the vacuum was somewhere around 11 inches water column by design. That is roughly 1/2 psi.