Quote:
Originally Posted by andrewwynn
You can tweak the sensor arm to counteract leveling problems no programming needed.
That said make sure the height measuring arm isn't rusted. They typically will jam up and bend the plastic arm not push the measuring arm.
Sent from my iPhone using Tapatalk Pro
|
I suspect that’s the cause of my sag in the right rear. I made some spacers to accommodate the lift, and I need to check that side and see if it’s shifted. Just a piece of aluminum that drops the sensor down so that it thinks it’s at the OE height.
As far as the PA Soft install, I gave up and had Tony do it remotely. The driver install is the tricky part, although the instructions are pretty good. My bucket was full however and I still have PTSD from trying to keep INPA working! He’ll have you change your system so that unsigned drivers can be erased (reverts back to “normal” after the next reboot), and send you a link that allows him a one time remote access to your system. It took him less than a minute to get the drivers installed properly.