Alright! You are halfway there! Next step is to take 6" of duct tape and fold one inch of one end back onto itself. THEN, press down the exposed 4" against the bare glass behind vapor barrier. Then, plug airbag back in BEFORE reconnecting battery (if you've disconnected battery) and screw one airbag bracket bolt halfway into door to secure it. The objective is to raise the glass 5" or so in order to line up hole in regulator with screw to remove old bracket/install new bracket. So, with airbag pugged back in, so that battery can be reconnected - you'll then re-plug window control switch. THEN, pull up on 1" flap of duct tape while pulling switch. If motor doesn't run - you've burnt it out...if it tries to help...you are in for a CHEAP fix! Use barely assistive motor, along with duct tape flap to line up that screw hole. You can then remove bracket holding screw and go for bracket/clips replacement. Any questions - msg me your ph# and I'll fill in the blanks! Good luck!


Sent from my iPhone using Tapatalk