Hi folks,

I know this is an old thread, but rather than starting a new one, I'm wondering if anybody has experience doing engine mounts on an E53 diesel (facelift version, if that makes a difference)?

I've done a heap of searching and found a few videos, but none cover the M57 engine.

I'd like to replace both mounts, but I especially need to replace the RH mount on a RH drive vehicle.
I've managed to get the mount free by undoing the 16mm nut on top and the two E12 bolts, but after raising the engine as far as it will go, I still can't get enough clearance to remove the mount.

I was considering undoing the bracket that bolts to the engine, but the front two bolts are impossible to get to.

Does anybody know if undoing the frame bolts on one side will provide enough room, or does the entire frame need to be dropped?

Many thanks!