Good info, Andrew. I haven't experienced a warning with my N62. Since I can't verify the location of MOTOR_UEBERTEMP in the eeprom and I don't have NCS Expert/Dummy, I only changed the lower four values for now.

I think I'll notice if the needle starts creeping up. I did notice that it had gone from straight up to about a quarter after making the adjustment this morning with PASoft. It took five minutes more or longer of it idling for it to center again.



If anyone has PASoft and has changed MOTOR_UEBERTEMP using the other tools, if you have a chance please check the line three above (could be two above depending on the offset of the gauge range string). It's in the upper right of the image included and my value is 7D (125). It appears before both gauge strings, as I wrote in a previous post, so could be the right thing to change.

Thanks for everyone's input!