Ahhh I'll see about that, this project is way over budget lol!! But appreciate the advice!

The crane is got had a busted jack cylinder....so i couldn't pull the engine. Got a new cylinder for 8 ton, hopefully it installs just fine.

So instead I started tracing the wires for A70006 Transmission control unit located under left side of rear seat.









dupe list

One wiring loom goes to the transfer case and solenoid/actuator, then the other connector goes into the loom of the body. This is what i need to undo to figure out where to splice on my X5 2002.

The ground is easy to find, the power goes to F205 40 amp in the trunk. For some reason I can't find the diagram for the distribution box right now.

The other 4 wires go to Can HI, Can Low, Diagnostics and F46.
Not too bad.


d12 roll