Quote:
|
Originally Posted by 2002Silver4.6is
From the way the instructions were written it seemed you were to disconnect the PDC by the PDC modual at the battery. THat made no sense to me. Disconnecting the harness that goes to the bumper does.
A) Remove the rear floor deck
B) Parcel tray too if you have one
C) Tire chocks and holder
D) Left and right aft trim pieces. They have 10mm black plastic nuts securing them.
E) Once the left aft trim is removed you can then unplug the PDC connector - if applicable.
F) remove spare tire -....duh!
G) Remover battery cover and refer to Mfr's instructions for installing that control module gizmo.
H) While you're in that area,...you'll see a large black connector -
that's the male end of the tow harness - remove the black filler cap. I
wasted 30 minutes on that stupid plug.
|
i think that most diy's are written after the fact... so its done by memory and sometimes, thats not very clear, especially when you wait a day or more till you start to jot down the notes... as you can tell, those instructions are backwards, since the procedure is really: A,B, F, C, D, G, then H...