Hello Tom,

Indeed, the importer told me that the cable connections are different here, however the basic connections should be the same I guess? Only difference as far as I can tell would be location of the connection (usa = at cd changer bay, NL = at radio module in trunk under spare wheel).
My kit came with a very long cable which connects to the radio module, and the ICElink is in the middle of my car, where the cradle is also located.

It would be great if you could inform me about the proper connections of the audio signal wires from the Icelink to the radio module.
Currently the white audio wire connects to pin 1, the red audio wire to pin 2 and the ground wire to pin 6.

If I disconnect pin 6 while listening the alternator noise is much worse (logically since there is no proper ground)

But I would just like to make sure this setup is OK?

see picture below for current diagram:



Deynos NL is not very keen on swapping my icelink for another one.......