Self-leveling suspension display
1 Off-Road
2 Standard
3 Access

The LEDs not only shows the current ride height, but also indicate changes:
>LED on: indicates the vehicle's current ride height

>Ride-height LED flashes while the LED for the earlier level remains on:
the ride height is being adjusted to a new level, either automatically or in
response to driver input at the button.

When the suspension reaches the new ride height the flashing LED reverts to continuous operation, and the LED for the earlier level goes out

> LED for current ride height flashes for roughly 3 seconds when you press
the button: change in ride height is not possible.

Raising
Available only when the engine is running AND doors are closed.

From Standard to Off-Road:
> Press button 1 while traveling at a speed of less than approx. 30 mph/
50 km/h.

From Access to Standard:
> Press button 1 or
> the setting automatically reverts to the standard setting once the vehicle exceeds a speed of approx. 20 mph/35 km/h.

Lowering
Available with ignition key in position 2 AND doors are closed

From Standard to Access:
1. Press button 2 while traveling at less than approx. 50 mph/80 km/h. The
system enters its preselection mode.

The preselection mode is canceled by pressing button 1 automatically once the vehicle exceeds a speed of approx. 50 mph/80 km/h or approx. 60 seconds after button 2 is pressed

2. Reduce speed to below approx. 15 mph/25 km/h within approx. 60 seconds after pressing button 2.

When you press button 2 at speeds below approx. 15 mph/25 km/h the system automatically lowers the vehicle to the Access level.

From Off-Road to Standard:
> Press button 2 or
> automatically once you exceed a speed of approx. 30 mph/50 km/h.

Hope this helps.

Curtis