Quote:
|
Originally Posted by diangelo1234
I've done a scan on all nav/radio modules and it show my nav-computer, the radio module and the monitor.
Setting the ignition key to 1 gives a lot of data.
|
Good, this confirms the ibus interface is working
Quote:
|
Originally Posted by diangelo1234
If I read settings from the navcomputer it tells me it's coded to a E39 and the languages GB and FR. As far as I can tell it's reading data from the Ibus.
|
Correct, it is working properly.
Quote:
|
Originally Posted by diangelo1234
21-4-2007 20:19:32: Code Nav Settings - Error when coding nav with new settings: Timeout (no response)
|
Questions:
1. What version NavCoder are you using
2. What is the nav software version fitted to your car? (eg: 3/1-63)
I think what you are seeing is NavCoder sending ibus commands that are not supported by your nav unit.
NavCoder has been tested on Mk3 nav 3/1-63 and Mk4 4/1-91 and 4/1-80, and works fine.
It is possible that older versions of nav units do not support all of the commands used by NavCoder - only trial and error will reveal if this is the case!
Please klet me know what happens, and send me an email (or PM) for quicker communication and diagnosis of this problem.