Get it here:
http://www.bimmerboard.com/members/k...l/NavCoder.zip

Changes:

v2.2.5 7 November 2007
Added 'Query VIN' to Code Nav dialog to read the vehicle VIN from the LKM
Added 'Diagnostics' to Code Nav dialog to read nav status
Added decode of TMC data request message (but I'm not decoding the TMC data!)
Added decode of radio/DSP Fader/Bal/Loud/Source selection
Added some more telephone message decoding
Fixed bug where diagnostic messages were being incorrectly decoded



v2.2.2 29 October 2007
Added ability to enter length byte as LL to I-Bus Message Test dialog
Added error trap to the Read System Parameters dialog
Added new known I-Bus devices 0x43 (Rear graphics driver) and 0xB0 (SES)
Added decoding of IKE sensor status message (handbrake, oil, gears, etc)
Added key number to immobiliser message
Added decode of telephone status (not sure I have everything!)
Added decode of tapedeck status (in part!)
Changed I-Bus device 'Graphic component' to 'Graphics driver'
Changed some I-Bus text
Fixed bug where PC would not display check control display < and > characters correctly
Fixed bug where Aux Vent On and Off were not decoded properly
Fixed bug where progress log wasn't being closed sometimes when coding the nav
Fixed bug where buttons were not being re-enabled sometimes when coding the nav

Regards, Jochen