Quote:
|
Originally Posted by rangerfan
Moving the wires from one pin to another. OK, what's involved in that? Is it simple enough to pull it out and push it back into another pin? Finally, how do I know the numbers of each of the pin locations on the connector? Is it stamped onto the plastic?
Will hit the garage once the kids are asleep.  |
Before you start removing pins, use your multi-meter to check if you have voltage across the pins identified above.
As for removing pins, there's a trick to it but it's not that difficult to figure it out. See page 21 on this document for some examples -
http://www.tvonnav.com/manuals/TVonN...anual%20v4.pdf
The numbers for the pins is stamped in the plastic (get out the magnifying glasses
)
Good luck!!