Quote:
|
Originally Posted by mtech8
[Drivers Side]
I went ahead and tried to remove the screws to access the drivers side. There are 4 of the 8mm ones. This allowed me some (very limited) access where I was able to feel the reflectors from the inside. But still don't see the 3 phillips screws. I think removing those should help access alot. Where are these located?
[Passengers side]
So I tried doing the passenger side first, the double sided tape is strong! I wasn't able to pry it off with a screwdriver. Really afraid of pushing too hard and causing the damage to the bumper or paint. Not sure how I'd get a heat gun in their either. Heat gun from the outside is a "no-no", right? Might strip the paint? Any tips on how to loosen up the reflector from the tape?
|
Driver's side:
I think they were the 3 Philips screws that you get to under the front bumper. Get to them from the front of the car. You have to be be able to pull the bumper forwards slightly so you can get your hand in.
Passenger's side:
The tape that BMW used is REALLY strong! Mine was slightly easier than KEF's but you pry on them from the inside (VERY gently with a flat head screwdriver) while PUSHING them in from the outside. You probably want two people on this. Obviously be very careful with the prying, you don't want to cause the outside paint to chip. KEF has picture of this in earlier post. There is no way I would use a heat gun on the inside or out.