Ahh.... this makes total sense. Anything special regarding removing this apparatus and putting it back? I did driver side last february, but i think maybe I have put at most 400-500 miles on it since then with the brakes needing replacement and all.
Yes I am going to do it the same way, taking the entire half shaft assembly out of the diff. I did leave the wishbone attached to the assembly. I also followed the instructions and torqued these bolts down with vehicle weight on them.
Quote:
|
Originally Posted by flyingmachine
Not tension bar/strut. It's the sensor that goes on wishbone(lower control arms), right? If I remember correctly, that's ride height sensor. It's quite easy to take it off. Are you gonna do it the same way? (take the inner CV joint out)
When you did the other side, did you leave the wishbone attached to the steering knuckle?
|