Quote:
|
Originally Posted by mrbmwx5
sup. farai +richchi. mr BmwX5 have an question for you two. how hard is it to install the silver sticker on the cluster? and if i do,do i need to remove the needles like RICHCHIRICH did and have the same problem (needles stucking too)
|
I actually did not remove the needles, I just had to stretch the new layover beyond the ends of the needles. It is actually not a sticker vs. an overlay......just about lines up perfect..a little off like on the gas gauge where the (0) is for being an empty tank, other than that not that bad........I have a pdf that krunk sent me that I could forward to your private email..to big for here...this was a good guideline!
Remove cluster with hex tool, open cluster with nedle nose pliers and a set of xtra hands(pain in the arse), line up and place layovers...use a little two way tape, also nees a torx tool to fasten layover under the screws(you'll see when you get there, snap in chrome rings, color needles(I did a silver sharpie at first(looked coool, just to much silver)then did red, the sharpie's seem to streak a bit)Next stop red finger nail polish), this will cover without streaking). ..and then just reinstall.....
RR
