ok, i know that my amp is bridgable, and yes it is one dual voice coil 10" sub that is wired to be bridged. this is what i have gathered so far:

i am going to connect the speaker high level wires into the factory 15 pin harness into #7 & #14. should the 4 speaker wires from the high level harness be bridged together if my amp is in bridged? (the amp does have a switch so i know it is bridged) i can just twist the 4 speaker wires from the high level harness together in pairs if needed. is the (chassis?) ground needed?

i am also assuming that the amp will still need to receive power directly from the battery, preferably with an inline fuse. is there still a need for the remote 'turn-on' wire? if so where do you recommend placing it?

thanks again.