Quote:
Originally Posted by ncx
Do you have the right torx driver? I'd allow 4-5 hours if you are going to take your time. Are you going to do it by yourself? Make sure to have somewhere soft and close by to place the bumper when you remove it (blankets/towels, etc). Also, have some things ready to support the mufflers when you drop them down. I used two small paint buckets last time. Finally, I suggest a nice six-pack of your favorite brew for the last yet critical step in this procedure.
|
Ha ha, already got the beer. I'll have to check the torx bit size, I have a set but will verify it has the correct size in it.
I was planning on using my floor jacks to support anything that needs to "hang", but that brings up a good question, to do this swap there is no need to jack up the vehicle right? There is enough room underneath to do the work without raising the vehicle?
Thanks for the advice.