So my steering wheel control buttons sometimes worked, other times...not so much. I figured, well.... there has got to be a poor connection in there somewhere....I suspected the slip ring, as it enables a connection between the buttons on the wheel and the car.

I have taken the wheel off before to fix a squeak, but then I didn't remove the slip ring....
So as soon as I pup it off, a freakin' ribbon cable jumps out, like a spring that slips loose and unwinds....
I knew of its existance, but I always thought that it is twisted up in a casing somehow and you don't really have to mess with it. Not in my steering wheel! ( 3 spike sports)
So there I am, winding it back, forward, sideways, don't really know what I'm doing....it's not winding the right way, always leaving one or two of the cables longer or turned. Also I didn't want to put it back the wrong way, turn my wheel while driving and snap it on half.
......And there is absolutely 0 info on this anywhere to be found.
2 hours later I figured it out and just wanted to post this, so that if someone has a problem like that can DIY it or contact me for help.

Here's how it goes: (I could not take the 2nd pic, as both of my hands were taken holding and twisting the cable.

1. Straighten the ribbon out completely, so all cables are untangled and paralel to each other, running from the steering column to the slip ring.

2. You can only wind it one direction on the column and only one direction on the slip ring, because the way the ribbon lays.

3. Since this enables your connection for the steering wheel when you turn it right and left, one assumes the ribbon must have even lenght wound on the slip ring and the same lenght on the column, otherwise it will snap as you make a turn, or worse.....it will not let you turn at all in one of the directions, so you will have to take wide detours going places and stuck with only a right or left turning X5.

4. When you have the same turns or lenght on both, the ring and the column, the last loop you make, will overloop in the oposite direction.

5. It takes approximately 14 fingers to hold the whole thing together, as you pup the slip ring back in. I only had 10 today and did it in 3 min. after figuring out the logic behind this crap.

PS. The slip ring connector was broken and all loose, so I did find the original problem. Now I will have to get a new one and do it all over again. Sweet.

Attached Images