Quote:
Originally Posted by redraiderx5
After I find these wires, do i have to tie the negative and positive into one wire then into an rca to connectit to the amp? (essentially taking 4 wires into 2)
The amp I have is a 1000w mono amp.
|
You take the 4 wires from the BMW wiring and connect them to the corresponding + and - coded wires on your hi/lo converter.
The Hi/Lo converter takes the factory speaker outputs and converts the signal to a useable one for your aftermarket amp. On one end are speaker and remote trigger wires, RCA outputs on the other. You then connect a set of Male/Male RCA's from this line out converter to your amp.
