Quote:
Originally Posted by m5james
I'm assuming you took off the back of the seat in order to run the wires. In order for the headrest to move up and down you still need to actuate the motor that controlled the stock ones. If the rods are sliding in the same holes as the stock headlights, then they must be touching the actuator. I don't know if the headrest TV kit has the same little ball at the bottom of the rods or not, but if they don't, there must be some way to connect them so they'll slide up and down via that actuator.
|
I think mine are manual headrests... the bars have no instructions as to how they go together etc so I'm hoping I have mine in wrong. They are installed but when you pull them up they just fall down.
...more questions for anyone who has these in there X
1) what is the green wire used for (installation manual is horrible... I think this is fo a power antenna maybe?)
2) If you connected the 2 red wires to a ACCY/IGNITION source where did you connect it and what color was the wire? For CONSTANT 12v+ the cigarette lighter wire mentioned before works fine.
Thank you