Quote:
Originally Posted by Weasel
But you got good resulte with the #0000 wool on the leather seats and anodized exterior window trim? Pictures?!?!? (my exterior window trim is the gloss black anodized)
|
3M Synthetic SW on the leather. Now that I think about it, it might have been the #000 (slightly coarser). My recommendation to folks would be to start with #0000 first, then #000 if needed. The idea is to micro abrade the surface, but not put in visible scratches. Done dry. Light touch at first, but then harder if needed. Some spots on the wheel and seat bolster edge required mild 'scrubbing'.
I'd post pics, but you wouldn't be able to tell anything from them. The leather simply looks matte flat, like from the factory. If I had black leather and had done a before and after, then pics might help; You'd seen sheeny, then flat.
I've done this procedure on my beige X5 Dakota leather, and also a little bit on the Z3 Coupe's Walnut Nappa leather. Neither showed scratches. It just removes 'the shinies'. Keep in mind that leather that is 'pebbled' like Dakota, will have some of sharper edges of the pebbling removed (if there's any left that is. Many older leathers pebbling are smashed and worn down by hands and arses.). Nappa, is not pebbled.
To give the steering wheel example; My Z3 Coupe's wheel is heavily pebbled (good.. as pebbling fights the shinies over the years). It only required a very very light buffing. This took out the tiny bit of sheen that was forming, and preserved all of the pebbling. THe X5's sport wheel leather was installed at the factory MUCH tighter, which meant the pebbling was smashed flat from day one. It had gone 'shiney' a couple of years ago. There, I used more pressure and more passes. This did remove what tiny amount of pebbling was left, but.. also removed years of nasty skin oils and dirt, micro abrading the leather, but not removing its dye. The wheel now feels fresh and new, and looks matte flat.
Once done to the wheel, it can just go shiney on you again (unless you wear driving gloves every time you drive). A very light 'buff' with #0000 once every 6w to 8w, wipe down with water. Your good.
Some day, way off, this process will eventually wear down to the leather's dye and the wheel will need recovering. But, I'll have had a 'new' looking wheel all that time. My only other choice is to have it recovered now. Syn SW.. once leather is starting to 'shine out' is a great option imo.
Super Fine #0000
3M CHIM Partner Support Site : 3M? Synthetic Steel Wool Pad 10119NA, 0000 Super Fine 18 cs
Extra Fine is the #000