Quote:
Originally Posted by KiwiJochen
Once in Service Menu use the rotary controller to choose, and Click to Select.
MENU always exits the Service Menu, that is how it is supposed to work.
|
Yeah I know but I need to press "menu" in order to access the servicemenu.. and when i let go it just exists the menu. Not staying in the menu. There is a "keypressing" fault.
Quote:
Originally Posted by KiwiJochen
NavCoder shows LOTS of valuable data
You can also use the BMBT emulator in NavCoder to send key presses and emulate rotating the control. This will prove beyond a doubt where the fault lies (BMBT or Nav unit)
|
Ok that sounds very usefull! cant wait for the hardware..!
Quote:
Originally Posted by KiwiJochen
Check the databus for integrity - any other odd problems?
Eg: if dash indicator lights do not work but outside lights do then you have databus corruption
|
I have actually a other bug with my lighting. I extended the wires from the xenonballast and xenon autoadjust motor in order to make more room for a cold air intake. But I used cable clamps and dident solder! That makes a bulb out light comes on and off even though the lighting works?! It goes away after 5min when driving.. I will solder it instead in the upcoming days. Could that be enough to corrupt the ibus/navi?
Quote:
Originally Posted by KiwiJochen
Hardflash not needed as you have already reflashed a few times
|
[/QUOTE]
Ok, Í though there was something about a ROM could be corrupted or sumting?